TGPWS 8: Hope it can only get better.

Status
Not open for further replies.

Muadeeb

Nissan al Gaib
Admin
Location
Dallas
tenor.gif
 

reaver

Lockers Installed
Supporting Member
Location
Caldwell, ID
That escalated quickly.
It did indeed. I cut the pex at the faucet, and capped it for now. I'm not even sure how to get the old one out (it's not held in via screws), so I'm going to see about mounting a new faucet next weekend. Got all the water cleaned up. Thank goodness for concrete floors.
I think the lesson we need to take away from this is that wives shouldn't be permitted to buy plants...
I'm pretty sure if she's not allowed to buy plants, I'm not allowed to buy tools or overland gear, and we can't have that.
 

Fromfrontier2Xterra

I bought a Taco
Super Moderator
Supporting Member
Location
All over PA

xyoverland

[fully disclosed]
Supporting Member
Location
Virginia
7D35FFEF-1BBD-4FFB-9A94-98B347426377.jpeg
I parked next to this silver first gen today with keys hanging from the ignition and a wallet in the little center console area. Sat like that for almost 30 minutes when the guy walked out of the barber shop. It was right out front, but still. I’ve seen cars gone quicker than he could make it out there.
 

Brunnie

Bumpers Installed
Supporting Member
Location
Colorado Springs
View attachment 22884
I parked next to this silver first gen today with keys hanging from the ignition and a wallet in the little center console area. Sat like that for almost 30 minutes when the guy walked out of the barber shop. It was right out front, but still. I’ve seen cars gone quicker than he could make it out there.
7 seconds is what it took for thieves to steal my GFs Xterra. We believe they had a key, with correct chip, so no broken glass.
 

reaver

Lockers Installed
Supporting Member
Location
Caldwell, ID
FML. Stupid dryer went out again. Unfortunately, brand new ones are both stupid expensive, and probably less reliable than a quality used dryer.

On the plus side, I got the new rear door for the trailer built. Haven't cut the holes for the latches yet. The outer door skin is 1/4in plywood. The main door frame is 2x6 in a horizontal ladder configuration. I was originally thinking I'd sandwich the 1/4in plywood outside 1/2in plywood, but I really like the 2x6 frame. I think I'll use 2x4 to frame the front doors. Getting closer! Once I get all the doors made, I can pull the hardware off, and start painting!
 
Status
Not open for further replies.
Top