Recent content by BillySpivitz

  1. BillySpivitz

    2023 Membership Drive

    Done-
  2. BillySpivitz

    2022 Supporting Membership Drive

    Done.
  3. BillySpivitz

    Rear Storage Area, Tools and Spares

    Are you able to fit the Tekton 3/8" socket set + case in the Rigid toolbox, or did you need to take them out loose
  4. BillySpivitz

    Xterranation is FAMOUS! They made it to TFL!

    very cool, nice job
  5. BillySpivitz

    2021 Supporting Membership Drive

    Done
  6. BillySpivitz

    Agm Battery / Charger Questions

    For the Odyssey, they have an approved list of chargers that they recommend for their batteries - I don't think the NOCO's are listed. Here's the list: https://www.odysseybattery.com/documents/ODYSSEY_approved_12V_chargers.pdf I remember when I was researching this, I came across a post on some...
  7. BillySpivitz

    goneMOAB 2020

    https://www.sunrvresorts.com/resorts/west/utah/canyonlands-rv-resort-campground/
  8. BillySpivitz

    The Greater Post Whore Society - Volume 5: New Blood

    is there a language filter? i can't find it in the settings. Or are people just typing ufck and shiat on purpose to circumvent
  9. BillySpivitz

    The Greater Post Whore Society - Volume 5: New Blood

    For light snow - maybe up to 6" - its good for what it is (I bought a cheaper, lower level one). Pretty quiet. Decent throw. Depending on if its a wet or dry snow, battery lasts maybe 35-45 minutes. Something like today though, its under powered. Went through two batteries, and haven't...
  10. BillySpivitz

    The Greater Post Whore Society - Volume 5: New Blood

    Our snow is light and fluffy most of the time anyways - agreed, don't need a snow blower here. I have one just due to the square footage of pavement I have to clear. Live on a double corner lot (so three sides of sidewalk) and have a two-car wide driveway. Saves me a lot of time with the...
  11. BillySpivitz

    Dash Removal. Help?

    I don't have any experience in doing this, but would suggest reading through the FSM. I think you'll be looking in section VTL, and IP for the instrument panels that you'll need to remove. https://www.nicoclub.com/FSM/Xterra/2012_xterra/
Top