Cptpackrat
Bumpers Installed
- Location
- Gillette WY
Well.... I bought a new cap and rotor plus plugs today. Im not spending $125 for wires just yet. My NGK wires look good so I will reuse them.
Wires are a 200K item in my mind unless there's a problem.
Those look great. No oil, no overheating, no detonation. Those are some quality used plugs.
www.vleds.comNow Im looking at converting all my exterior lights (turn signals, brake lights, stops) to LED.... gonna make a list and figure out costs, might happen sooner than I was planning!
www.vleds.com
Go there. And nowhere else. They're not the cheapest, but hot damn all their products are on point.
Are you still using the factory 3rd brake light? Or do you have a tire that renders it useless?
Don't waste your money. The bulbs don't fit right in the 3rd assembly. Mine fell out of the sockets every other week. Just take the bulbs out. Mount something to the roof rack if WY gives you shiat about the 3rd light.I have a big ass tire that blocks it, I still may swap it for LEDs just because.
Don't waste your money. The bulbs don't fit right in the 3rd assembly. Mine fell out of the sockets every other week. Just take the bulbs out. Mount something to the roof rack if WY gives you shiat about the 3rd light.
Yes. They are great for the interior bulbs. And for the turn signals you just need to replace the flasher module under the dash. It's a $12 part. Also available from VLEDs.good to know, do the VLEDs have built in resistors and such for interior bulbs?
also, if you gonna make the turn signals LED youll need to wire in resistors(im sure you may already know this, but just incase). i have them for my rear lights, that and my tail lights are custom.
i learned something today.You can.....or...you can replace the flasher unit under the dash that is compatible with LEDs.
nice snow pics. but if i could back to LED for just a second...
the LED cluster, does the dimmer still work with them?
also, if you gonna make the turn signals LED youll need to wire in resistors(im sure you may already know this, but just incase). i have them for my rear lights, that and my tail lights are custom.
Silly Chebby drivers.
Hate when stuff breaks.
Sent from my iPhone using Tapatalk
how much do the alcans run? ive heard somewhere around 750
I may have a little trick up my sleeve in the not so distant future with that F250 D44 I have at work.
Her sucks man. Was all that stuff replaced on the last belt change?
I have a OEM water pump ready to go in. Was yours OEM or aftermarket?