TGPWS 10: The Tentacle Invasion

Xterrorista

Charcoal Briquette
Supporting Member
Location
Denton, TX
"GM Performance has announced the ZZ632/1000 a 1,000+ hp crate motor! The new ZZ632/1000, which sounds more like the name of a Terminator than a crate motor, will produce 1004 hp and 876-lb ft of torque. What’s even more impressive is that the ZZ632/1000 will be putting out those numbers naturally aspirated and on pump gas. That’s right, no turbo or supercharger will be found on this bad boy..!"Screenshot_20240405_081943_Facebook.jpg
 

relentless044

Silver Slut
Supporting Member
Asked body shop mijo to cut my fenders for a 12 of modelo. Cause if I did the autism would be evident. And yes I’m still salty they don’t fit no rub
 

Prime

Shut up Baby, I know it!
Admin
Location
Denver Adjacent
Rough math based on box size is 6k books. Not including large special volumes and the closet full of loose books I've set aside for grading. Every time I turn around. More ufcking comics.

And I'm willing to bet that about a 3rd of them are just obscure random garbage that aren't worth the paper they're printed on.
 

relentless044

Silver Slut
Supporting Member
Rough math based on box size is 6k books. Not including large special volumes and the closet full of loose books I've set aside for grading. Every time I turn around. More ufcking comics.

And I'm willing to bet that about a 3rd of them are just obscure random garbage that aren't worth the paper they're printed on.
That’s plenty for the one in San Luis including fixing the fender :)
 

relentless044

Silver Slut
Supporting Member
I really want morrimoto's for the f2expensive, but $1700 and the halogens that work perfectly keep getting in the way
 

Prime

Shut up Baby, I know it!
Admin
Location
Denver Adjacent
I've been holding off on building LED projectors for the truck. I have a really clean pair of OEMs. But I don't know how long I'll be keeping this truck.
 

Prime

Shut up Baby, I know it!
Admin
Location
Denver Adjacent
One Subaru headlight done. Gonna do the other one tomorrow. Also doing full LED's on the exterior lighting while I'm at it.

Then comes the arduous task of removing the entire front of the car so I can swap the headlights in and do all the wiring for the HIDs.
 

Prime

Shut up Baby, I know it!
Admin
Location
Denver Adjacent
I really hope I only have to do the load resistors for the turn signals in the front. I don't want to have to rip the back of the car apart too.
 
Top