No-weld shifter extention for post body lift.

[DJQuin]

So, I don't have the ability to weld on the shifter extention and I was looking for something to solve the problem of it being sunk down. I found this little guy on eBay and thought I'd share. I searched and didn't find any other mention of such a thing, but if it's been mentioned before, I apologize.

http://www.ebay.com/itm/BLACK-ANODIZED-10mm-x-125-x-3-Shifter-Shift-Knob-Extension-3-inch-3in-/261053071493

 

[Roadwarrior]

I didn't think it being sunk was too big of an issue. Some might disagree but I didn't think it was that bad. Nice find though.

 

[KChurch86]

Nice find.

 

[NismoFire]

I didn't think it being sunk was too big of an issue. Some might disagree but I didn't think it was that bad. Nice find though.

Depends on if you have an automatic or not...I worry about mine.

 

[robcarync]

Is this for the transfer case lever?

 

[NismoFire]

Is this for the transfer case lever?

Could be either transfer case or the manual trans shifter.

 

[DJQuin]

Yeah, they are the same thread pattern I believe. But in my case, the transfer case.

 

[Creepy Cruiser]

Very nice.

 

[Prime]

I like having the shifter lower. Still works great and if my transfer case shifter was taller it would hit my CB in 2wd.

What I'd REALLY like is a short throw shifter for the transmission with positive stops. The factory manual shifter feels like guessing on some of the gears.

 

[Nd4SpdSe]

I like having the shifter lower. Still works great and if my transfer case shifter was taller it would hit my CB in 2wd.

What I'd REALLY like is a short throw shifter for the transmission with positive stops. The factory manual shifter feels like guessing on some of the gears.

I as well like the "shortness" of the shifter with the body lift and the Tcase shifter fits fine as well, but I dont have issues with the stops, I have no issues even shifting my left hand, but that's typically a symptome of worn shifter linkage bushings.

 

[Prime]

I as well like the "shortness" of the shifter with the body lift and the Tcase shifter fits fine as well, but I dont have issues with the stops, I have no issues even shifting my left hand, but that's typically a symptome of worn shifter linkage bushings.

I don't have problems per se. But, I've had lots of experience driving cars with aftermarket shifters and it makes a world of difference when you have positive stops on the shift gates.

 

[metzican]

does anyone know if the thread on the 2nd gen is the same as the first?

 

[DJQuin]

Based on the info I found, it looks like it's the same thread pitch.

 

[knightrider]

I have yet to find a Nissan with a different pitch, I've had the same shift knob in 5 different Nissans from 1970-2012

Sent from my One using Tapatalk

 

[metzican]

Ok, thanks for the info.