This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Hey did you do a write up for this? There is no wiring write up on the forum and I'm struggling with my light bar for some reason. Maybe I'm a tard when I comes to this stuff but there's really nothing here
Where they're at in the picture... no, hardly nothing during the day. However, if you move them down to where they're resting on the bumper I'm pretty sure you'd be able to see them during the day. I just don't prefer the look of actually seeing the LEDs. I like it better where you see the glow.
When I was installing mine, I must have paced back and forth for 10 mins after I put the template on lol. Just take your time, check and triple check measurements and then go for broke!
You could get a grease pen and tape up the snorkel where you think it should be then draw an outline. Then measure how far the hole is from the edge of the snork and theres your template. Well at least in my mind it is lol
Template is made! Looks a little sketchy but it should work haha
Also, I noticed on the snorkel... It has a bump below where the 3" air intake is and it looks like the body was resting right there. Check out the picture. It seems like the hole is going to have to be bigger than 3" for the whole snorkel to sit flush.. What do you guys think?