Did some interior plastics painting, used bedliner.
Then started my CB install.
I started with the stock setup in the dash and removed this piece here.
After that bracket was out, I cut the two lower tabs off the stock head unit and slid it in lower using the holes for the lower mounts. (Lots of filing was required.)
Then I cut the trim piece that went around the head unit.
I actually had to trim it more, I had to cut out the bottom piece of it and make it into a U shape instead, more filing and sanding was done.
I now decided how I wanted to run my wire, nothing to fancy but enough to keep it all hidden for the most part.
I don't have a pic but it runs underneath the rug up the drivers side and up around the gas pedals and comes in from behind in the dash.
I wired it right into one of those 12v plugs on the truck and ran all the wires nicey nice through the back, tucked em in.
Finished without the last trim piece on.
Finished.
The CB actually sits in very snug, took some finesse to get it in so I don't even need a bracket to fasten it in. I just need to get it tuned now officially I get a few channels right now. I have a PA wire ran, I need to get a new PA speaker for it though which should come soon. Overall, I'm pretty happy with it.