- Location
- Virginia
This was one of those things where there was no video when I went to look for one, so I made one. Mostly sped up and not in depth at all - tried to keep it trimmed to only show what was needed.
Tools needed:
-10mm wrench
-10, 12, and 14mm sockets and ratchet
-Flathead screwdriver (for hood strut, it applicable)
Steps:
1. Open door and remove fender bolt with 10mm wrench
2. Under the hood, remove all fender bolts
3. Gently pull fender away to expose two bolts next to the hood supports
4. Remove those two bolts
5. Place ditch light bracket (push against black plastic at corner of windshield to align it with holes)
6. Place two new bolts and tighten down to barely snug
7. Once snug, gently align it into place (you can slide forward or backward) and tighten down the rest of the way
8. Slowly move hood up and down to check clearance
9. Make sure fender is aligned where it was, and replace the rest of the bolts
10. Repeat on other side
Up close of installed bracket:
Tools needed:
-10mm wrench
-10, 12, and 14mm sockets and ratchet
-Flathead screwdriver (for hood strut, it applicable)
Steps:
1. Open door and remove fender bolt with 10mm wrench
2. Under the hood, remove all fender bolts
3. Gently pull fender away to expose two bolts next to the hood supports
4. Remove those two bolts
5. Place ditch light bracket (push against black plastic at corner of windshield to align it with holes)
6. Place two new bolts and tighten down to barely snug
7. Once snug, gently align it into place (you can slide forward or backward) and tighten down the rest of the way
8. Slowly move hood up and down to check clearance
9. Make sure fender is aligned where it was, and replace the rest of the bolts
10. Repeat on other side
Up close of installed bracket:
Last edited: