rolling rock
First Fill-Up (of many)
- Location
- PA
Love it! That is one fine first gen xterra!
Wheel end bearings have just been replaced. I guess the cheapest way out would be pinion and carrier bearings along with the inner and outer stub shaft on the drivers side.New bearings all the way around.
Sent from my iPad using Tapatalk
Actually theres quite a small story behind those.Yukon? You go, big spender!
Yep. Otherwise someone is very talented at stapling the box back together and wrapping the shafts up. Also there's a Yukon sticker and book inside.Odd. Ate you sure they're Yukon? And not just a box?
Sweet rig man! Love this build..
Hey I was wondering how well the calmini sas kit has held up, was it worth it?
And did you just do a spring over in the rear? Did you use the same brackets?
New bearings all the way around.
Sent from my iPad using Tapatalk
Looks SWEET! makes me anxious to get my kit!
Maybe just the cutoff wheel.Man it's looking good. Time to get out the sawzall!
Do it. Do it now.Looks SWEET! makes me anxious to get my kit!
Get on it.Thisssss, I'm ready to just build the dang axle
Sent from my iPhone using The power of the internets
Yeah. With the help of a couple friends, hopefully it'll be in before winter.What happening? Are you back at looking at a v8 swap?
Yeah. With the help of a couple friends, hopefully it'll be in before winter.
Sent from my SM-N920P using Tapatalk
I bet the FSM does.
It's in there, but not in a single place like the Gen 2 manuals. You'll need to do some digging to get all the info.