Bikers Cage - PirateX

BikersCage

Test Drive
Location
San Diego
Bikers Cage - PirateX **Now with Sliders**

Username: BikersCage
Real Name: Richard (Rich)
Year: 2005 One and only owner
Make: Nissan
Model: Xterra
Trim: Off Road, 6-spd
Color: Night Armor




Its been a little while since I posted over here. I really only posted in a few threads. The X is coming along nicely. I still need sliders and my onboard air in the next two months. Then I shall get out there and get some!


Let me know what you think, and where I may be able to go to get more trail worthy, but still being able to daily drive if I have to especially in the winter.
-Mods-


Suspension/ Tires/Driveline
- SPC UCA
- TJM Extended Travel Coilover
- OME Dakar Rear Leafs
- Solid Steel Axle Degree Shims
- TJM Rear Gold Series
- 4x4Parts Adjustable Lift Shackles
- 285/75/R16 Duratrac
- 1.5" Wheel Spacers from SD_Frontier


Exterior and Armor
- Shrockworks Rock Sliders
- Plasti Dipped Almost all plastics that can fade
- Stock Off Road Skids
- Front Rear Bumpers (Oct 13)
- Custom Drop in Rack From Xtracrispy


Recovery Gear/Other Goodies
- D Ring Hitch Receiver (Until Rear Bumper Comes in OCT)
- Basic 10klb rated recovery strap (gift from family).
- Basic Hi Lift


Towing
- Factory Tow Package


Interior/Electrical
- Cobra 29 LX & 3' FireStik
- Upgraded D Rings In Cargo Area
- Replaced Hatch Struts 175 lbs
- Complete LED Swap VLED.com White
- Due in May Custom 15lb CO2 Tank Collaboration on SCCX


Removed
- Mudflaps
- Rear swaybar




PHOTOS:
Current Look


892926_10200831418046550_89477455_o.jpg



Stock
Jeep Parking only....lols
155687_605759596357_7792027_n.jpg



Me
61469_4692665153387_32635125_n.jpg

407371_10200185167450689_743100992_n.jpg
 
Last edited:

BikersCage

Test Drive
Location
San Diego
They were not to horrible I had to trim about an inch of fender. You can leave the top screw and start your cut there so you have a place to keep it attached. I cut it so I could bend in sheet metal to attach the other screws also.
 

drbandkgb

Titan Swapped / SAS'd
Founding Member
They were not to horrible I had to trim about an inch of fender. You can leave the top screw and start your cut there so you have a place to keep it attached. I cut it so I could bend in sheet metal to attach the other screws also.

Lol sorry I was thinking spacer for lift lol..
 
Top