Almost Stalls when coming to complete stop...

Matt Benson Jun 24, 2018

  1. Matt Benson

    Matt Benson Test Drive

    Messages:
    11
    Hello,

    First, I apologize if this has already been talked about. Through searching the internet and forums I haven't found a definitive answer.

    My 2011 Xterra S has always "stuttered" a little bit when coming to a complete stop. For the past two weeks after the engine is at normal operating temperature and driving a highway speeds for 10 plus minutes and coming to a complete stop the motor acts like it's going to stall, then jumps back to normal idle at 650 RPMs.

    I'm going to check all my vacuum lines for leaks/cracks and clean my MAF sensor. After that I'm lost. The motor is not throwing any codes.

    Thanks,
     
  2. Prime

    Prime Some Kind of In Charge? Admin

    Messages:
    34,689
    Location:
    Denver-ish
    There was a low idle condition on some trucks. My wife's Pathy does it every once in a while. Idle should be closer to 750-800 rpm. It takes a Consult scanner to adjust the idle. So a dealer has to do it.
     
  3. JeffPro4x

    JeffPro4x Hot Pipe Moderator Supporting Member

    Messages:
    8,671
    Location:
    Glenside, PA
    Or a bullydog. But I do believe there was a TSB about the low idle.
     
  4. Prime

    Prime Some Kind of In Charge? Admin

    Messages:
    34,689
    Location:
    Denver-ish
    There was
     
  5. Matt Benson

    Matt Benson Test Drive

    Messages:
    11

    Thanks guys! Again! Can you please explain the TSB? Sorry, noob right here and trying to learn.
     
  6. 12° North Industries

    12° North Industries Bought an X Site Sponsor

    Messages:
    69
    Location:
    Near The Pointy End, NV
    TSB = Technical Service Bulletin ;)
     
    Matt Benson likes this.

Share This Page