Search results

Hey all, this is probably a dumb question, but one I haven't seen answered or even discussed anywhere on this site or others. I'm likely just bad at googling. I have a 2013 S with SW bumper with winch, engine and rad skids, sliders, and rear bumper. I recently purchased the AllDogsOffroad 5100...

Hey All, So I just got back from the tire shop with these great Yokohama Geolander 285s. Unfortunately, this little nubbin in the back front fender rubs on both sides (one more than the other). Any thoughts on how to fix this little issue? I'm assuming it will involve some trimming? Is the...

Title says it. Looking to buy, I'm in NorCal willing to travel within reason to meet. I have a stock bumper I'm willing to trade. Looking for Rad Skid and Bumper with Hoops, will take the winch too if offered. Looking to spend around $1500 for Bumper, Skid, and winch in decent condition.

Hey All, Just got back from a trip doing the old Mojave Road. For those of you familiar, against my better judgement, I bent to peer pressure and completed the Afton Crossing. After the Afton crossing and before the train trestle is another developing hole...and here the bottom is soft; I got...

I got inspired by the videos here and here posted on another thread on another site (TNX) I decided to take the best of both worlds and design a roll-up awning with folding legs. Materials: 3 sticks of 1/2" x 10' EMT 1 4" ABS Pipe 10' long 1 4" ABS Cap 1 4" ABS Cleanout 1 8' x 10' Heavy...

Hey all, recently I've been noticing two things which may or may not be related. 1. A rattling noise when going over bumps, seeming to come from the engine bay near the front. 2. During idle, especially when in gear, there is a loud clicking that sounds like a solenoid switch followed by 1-2...

Anyone with a Mean Green Alternator that has also disconnected their VVC device and tracked their voltage? Frequent lurker, infrequent poster. Looking for some people with experience with a Mean Green 200amp alternator. I'm most interested in the voltage output after a swap, especially if...

Hello all, I've been off the boards for a while, work went crazy and I've spent all my spare time trying to keep my life in order. Part of that was finishing up this build which started back in April and is finished today, 7 months later. Without further ado, here's how I have built an...

Username: Make: Nissan Year: 2013 Model: Xterra Trim: S Color: Night Armor Code Name: "Night Fury" Mods: (Newer mods at the top) Interior: 4/27/19: Rear Switch Plate and Junction Box (Post #5) and How To 7/1/17: Pioneer AVH-391BHS Exterior: 4/20/19: Beginning of Operation: Batteries and...

Sliders, skids, Bumpers, what've you got!? I'm interested in functional gear that has been used and might need a little TLC. Want to upgrade to a brand new Hefty aluminum bumper, but want to get some return on your shrock? I'm your man. I'm especially interested in front plate bumpers and...

Notes: *GeoXplorer's post over on TNX is one of the most complete write-ups with full pictures of everything. I used it often. I would read his version first, then read mine. His goes into MUCH more detail. *I completed this from setup to clean up in about 10 hrs (maybe 11) including runs to...

OK! Finally have some time to write this up and finished the wiring yesterday! * I had already completed my Dual Battery Install. * I was also working on rewiring my aftermarket backup camera and adding in the wiring for my on-board water system so those are some of the wires you will see...

Annnnnndddd yup you guessed it, another refugee! Name is in my screen name. Thanks for welcoming us in! I've got a 2013 X that I'm working on getting ready for light offroading/overlanding. Avid outdoors man on land and sea. Fisheries Biologist. Open book, ask me anything. Side note...