Shrockworx sliders question

akuria Jan 24, 2016

  1. akuria

    akuria Wheeling

    Messages:
    561
    Location:
    San Francisco, CA
    I have a beat on some used shrock sliders for a good price but they are for the 2" BL and I do not have the BL. Can I just drill new holes in them to lower them down to fit or are they no good for me?
     
  2. XTP_Dyer

    XTP_Dyer First Fill-Up (of many)

    Messages:
    298
    Location:
    Nashville
    Just have the person send you a picture of the sliders with the mounting plate. If the deal is sweet enough, go either way..you seem pretty handy.
     
  3. Slasa

    Slasa Lockers Installed

    Messages:
    1,751
    Location:
    Denver
    I don't think there is enough room on the plates to lower them just by drilling new holes. You would have to cut off the mounting arms and re-weld them into position.


    Sent from my iPhone using Tapatalk
     
  4. Cruecible

    Cruecible Titan Swapped / SAS'd

    Messages:
    8,888
    Location:
    Albuquerque, NM
    Sell them to me if they don't work, add a little extra for your "finder's fee", and bam, you're better off than before lol
     
  5. akuria

    akuria Wheeling

    Messages:
    561
    Location:
    San Francisco, CA
    Yeah. That's what I was afraid of.


    Sent from my iPhone using Tapatalk
     
  6. akuria

    akuria Wheeling

    Messages:
    561
    Location:
    San Francisco, CA
    I think I'm going to pass on the sliders and order a set of universal ones for $180. Then weld it straight to my frame.


    Sent from my iPhone using Tapatalk
     

Share This Page