Cel code 1447 - evap purge control / monitoring

[NMTerras]

What the heck is this?

 

[Maxterra]

Probably a stuck purge valve back by the charcoal canister, left rear corner.
Quite offer you can remove the valve, wash it out with cleaner and give it some wd40 or similar to get it moving again.

 

[drbandkgb]

BL related

 

[RacerXXL]

BL related

OP does not have one.

 

[drbandkgb]

OP does not have one.

Yeah he does... 1"

 

[RacerXXL]

Yeah he does... 1"

Must have missed it in his build, sorry. Still don't see how a BL would cause the issue especially a 1" BL.

 

[drbandkgb]

If you read on CX there had been quiet a few BL's that run into this issue.. Most of the times its due to people not undoing the clip before lifting.. Plus you take in the age of these things..

 

[NMTerras]

Yep - 1" BL, and I did not unclip the line behind the passenger side shield that goes back to the evap canister. It had cracked and severed. Repaired. Engine light still on, but I'll give it a couple days and then reset it/re-read it if it doesn't turn off

 

[RacerXXL]

If you read on CX there had been quiet a few BL's that run into this issue.. Most of the times its due to people not undoing the clip before lifting.. Plus you take in the age of these things..

Yep forgot about that one.

 

[Cyclemut]

Gotta read the directions!

 

[NMTerras]

Directions? There was directions?

 

[Cyclemut]

It's the last thing that a man reads, typically throwing it away with all the plastic and boxes.

 

[NMTerras]

Oh. Those.
Didn't have any of those.

 

[Cyclemut]

The manufacturer probably said "Oh, the Xterra kit? Yeah, he's probably on 20 different forums and has done 30 of them already, save the paper, he knows what he's doing."

Fuggars!

 

[NMTerras]

Yeah I just ordered pucks and bolts and did it...loosened a few things like heater hoses and power steering fluid reservoir. Evap lines never even occurred to me...