SAS help - Calmini shock towers
- Thread starter drbandkgb
- Start date
NMTerras
Suspension Lift
- Location
- New Mexico
I'd go check out alpine spirits thread on ronin...lots of pics you just have to find em
NMTerras
Suspension Lift
- Location
- New Mexico
Kev's thread has several pages of up close stuff from when grandpa did his thing with the haxle
- Location
- Columbus OH
Dave you are going to trim all of it off, down to the bare frame rails on the outside. Personally I would plate the frame in that section while it is open, but that is just me,, well and a couple of others that have or would do the same thing. gramps being one of them.
- Location
- Huntsville, AL
The Calmini kit is bolt on in most places and requires stock mounting points.
- Location
- Huntsville, AL
Dave, I don't think he can get much clearer; short of coming and marking it on your truck. :lolz:
Pro-2X
Suspension Lift
- Location
- Rockmart, GA
Dang, I've never even owned a first gen and it seems clear enough to me.
NMTerras
Suspension Lift
- Location
- New Mexico
Yep. And like Andrew said, plate it while you're in there.
Nice pics Casper...was that from when you sold off / removed the whole SAS system?
Nice pics Casper...was that from when you sold off / removed the whole SAS system?
- Location
- Smyrna Tn
When you get going on this just let me know I'll help out, I couldn't last time cause of work.
- Location
- Smyrna Tn
I am off all this next week, I may swing by next weekend.Im back at it this week
Hear let me know
- Location
- Smyrna Tn
:kewl:
Sounds like a plan to me......