3dmasters
Test Drive
- Location
- California
Hello Guys,
I just wanted to post a way I was on youtube for a vg3.0 engine.
I need to remove this gear to replace the front main seal.
Parts needed,
2 each 6MM X 1.0 X 100MM grade 8 or higher
6MM tap and a 5.2MM drill bit http://www.lowes.com IRWIN HANSON 2-Pack Metric Tap and Drill Set
1 steering wheel puller kit from http://autozone.com
Center punch http://www.homedepot.com
RUST RELEASE PENETRANT SPRAY WD40
Part 1,
Part 2,
Give any Feed back guys good or bad
I just wanted to post a way I was on youtube for a vg3.0 engine.
I need to remove this gear to replace the front main seal.
Parts needed,
2 each 6MM X 1.0 X 100MM grade 8 or higher
6MM tap and a 5.2MM drill bit http://www.lowes.com IRWIN HANSON 2-Pack Metric Tap and Drill Set
1 steering wheel puller kit from http://autozone.com
Center punch http://www.homedepot.com
RUST RELEASE PENETRANT SPRAY WD40
Part 1,
Part 2,
Give any Feed back guys good or bad