So today's project try to start putting it together since the insides are all done.
So I started assembling the inside with all the accessories. Wow what a pain in my ass sitting on that hard wood all day.
Mounted up the curtain rod above the window area. Still have to make the curtain. And Mount the rod above the door area too.
I soldered up the wiring for the reading light.
Then I mounted it up.
I then mounted up the plate to hold the DVD player.
After this I mounted the DVD player. So I could solder up all the wiring.
Soldering some wiring. Had to use liquid tape once. GRRR. The rest are heat shrink.
Turned the DVD player around the way it is suppose to be. Then I put up the finishing piece to make it all look nice.
What it will look like open.
I then went on and started mounting all the interior LED lighting inside the cupboards.
Still have to tuck up the wiring nicely. But this shows the door activated switches. When the cupboard door opens that specific LED will open.
You can see the switch and LED light together here. I mounted all 4 LED light strips on the inside.
Then I started wiring up the main hub of an electrical panel. With all the switches. I got about half way through it. Along with this mounted the fuse box and the inverter. I know it looks like a cluster **** but it will be cleaned up when all the wires are in.
A good view of the front of the panel. The 120volt plug, inside/outside temp gauge, Battery Volts meter, 2x 12volt plug in, and switches with room for expansion.
I also mounted then interior corner aluminum panels today as you can see in some of the above photo's.