Joe, any chance you did a write up on how you installed the 510's in the factory location? I love that look, and I intend to ruthlessly copy it!
Well if you were going to Moab we could swap bumpers and I'd cut yours up.
I didn't take a single photo, when I did it I can tell you on how i did it, basically you'll need the
Piaa 510
a dremel with a cut off wheel
Zip ties,
if you have a drill and drill bit you might be able to them up to the bumper bar, they've been I thee for almost 2 years now and I've had no problems
Then get a rough idea of what to cut out to get the rock guards thru the factory hole, if I recall it was about half the decortive circles around the factory opening, once they fit thru you're done cutting.
If you're using zip ties to secure them you'll need to take the lower bracket off the lights place them in the holes and loop the Zipties thru the
Factory brackets until secure you may need to make your own holes as well to get it just right, then they should be secure enough to adjust in terms of aiming and what not, then wire them up and you're good to go
Sent from the Nighthog mobile command unit.