cobra

I wanted a power inverter hard wired into my X so I decided to do another write-up. Hope this gives y'all some good ideas. I used the following equipment: Cobra CPI-875 Power Inverter SR-80 High Current Relay Distribution Block Ground Block Inline Fuse (4ga) Mounted Inline Fuse (4ga)...

Ok so this is my CB install I did in the dash of my 2001 Xterra. This will work on the 2000-2001 Gen 1 Xterra's but no other.. First you must pull the plastic ring off from the radio.. This is very easy because there is only two screws at the bottom of the ring. As you can see the two holes...