Search results

Done. Tapped off of the front marker lights and good to go.

Welcome! I'm jealous of the terrain over there!

Welcome!

I also used this kit multiple times with great success

Welcome. Way to stick with your vehicle despite the troubles early on!

Welcome from another newb

Welcome!

That's the plan at this point. I hate wiring!

After looking pretty carefully at the existing wiring, I'm sure that the factory wiring is no longer present for the markers. Anyone have a suggestion for an easy fix? I assume that it can be anywhere from as simple as jumping from the front markers to as involved as adding wiring and relay etc.

I'm definitely going to have to do some investigation into what happened to the wires. I'm pretty sure that the front end had a small fender bender and may have caused the wires to no longer be present.

When I got my 04 X it had no side marker lights. I haven't looked really hard but I don't see any connectors for them. Any idea where they come off the harness? I got new replacements and worst case scenario I can wire them in without the stock plugs. But with that said, do the sides function as...

A couple years ago I got some touch up paint from Auto Zone. I remember they had a rather large selection in-store. Might be worth checking out

Looks great! Taking care of faded plastic is always a huge improvement.

I had the same experience but with the side to side trimming. Measure twice, cut once... oops!

I certainly prefer the round headlights, despite the fact that they aren't most people's favorite.

I'll be sure to ditch the boards if I go offroad. I may remove them anyway as I don't find them very useful when getting in.

Just a couple pictures of my X.

Welcome from Minnesota!

Without any codes or anything obvious, I would be looking for a possible vacuum leak. I don't know what else would cause it to increase.

The 2004 that I recently picked up was already relocated. It also had a code for the knock sensor that we cleared. It hasn't come back but if it does, I'll replace the sensor. I don't think I would completely ignore it. Ideally, I think it is best to replace it in the factory location, change...