Search results

I hate to let this truck go. for about 5 years i have thought of selling but the 6 or 7K wasnt worth what i was giving up. Kept working on for fun even though i haven daily driven in over 4 years. Now i have a surgery bill from the VET for the same amount and its time. I put like 200 miles on it...

Just wondering if anyone had dropped the front axle/ diff other than the 1" or less gotten from the offset bushing replacement. I was looking that front cross member and flipping it upside down may even work or replacing it with square tube and using the lower bolt only? the rear cross member...

I have some play in the driveshaft coming out of the rear of the transfer case. It makes a rumble strip tire noise when letting off the gas almost to the point of removing your foot completely. my guess is the drive shaft is vibrating there. found a whole new t-case for 200. not sure if a...

Has anyone ever changed the rear axle outer bearings on their X? I see its common on 2nd gen xterra's but haven't found good info or how-to's on the 1st gen. not sure its my problem but possible bent axle or bad bearing. Feels like a flat spot on the wheel sometimes and i know my rear tire was...

I have an 04 na 3.3L with 190,000 on it. Trying to figure out which route to take for parts. The lean code could be a ton of problems. I have a OBD2 scan readout of the Fuel trims for starters. The O2 sensors all seem to be within normal operating conditions. The Bank 1 seems to be the issue...

I have an 04 with the 3" +3 leaf pack and some new OE Heavy duty springs from general Spring that i think add about 3/4 to 1" of lift over original pack. I had the AC shackles but the rear was so high up i added the factory shackles back in and im getting some low speed vibration. I had 3" lift...

I have 4 Firestone M/T 285/75R16 with more than half the life (12-15MM) on them mounted on the 1st Gen 4 spoke rims. The rims are primed and painted black a few years ago so some chips have happened. The tires are good tires, just have an extra set and need to make room. Minimal wheel weights...

I have had this for a while on and off but now more apparent. first, when I am driving thruway speeds and let off completely, nothing. same speeds and slowly decelerate or 95% let off and still have some pressure on pedal, I get a rattle like a pinion bearing problem. - I don't have any leaks...

I recently added a trans cooler with e-fan that i didn't plumb yet but have that fan on, pushing through the AC and radiator and directly wired in with the relay that controls my radiator e-fan. My issue is that when driving for longer periods of time (45min) on the highways, I get extremely...