- Location
- Glenside, PA
I've been asked about my rear storage setup and what I carry on the trails a few times, so I’ll detail it here. I'll add pictures later.
I built an interior rack out of the Harbor Freight hitch basket (this has been documented by a few people I believe. I can do another write up of that if needed). My rack has been made shallower to allow my Power Tank to fit in the rear corner.
Also have 1 of the Hep’s Window panels.
I built an interior rack out of the Harbor Freight hitch basket (this has been documented by a few people I believe. I can do another write up of that if needed). My rack has been made shallower to allow my Power Tank to fit in the rear corner.
Also have 1 of the Hep’s Window panels.
- 8 Gallon Action Packer #1
- Alternator (used junkyard)
- Full set inner and outer tie rods (Hitachi, OEM)
- Serpentine belt
- Hub assembly
- Front ABS sensor
- U bolts
- Center Pins
- SPC ball joints
- Spare nuts, bolts etc
- Big C Clamps
- U Joint
- Spare front shock, no coil
- 1-3 Spare CV axles, depending on length of trip
- 8 Gallon Action Packer #2
- Oil - 2qt
- ATF - 2qt
- Coolant - 1 gallon
- Rear diff fluid - 2qt
- Front diff fluid - 2qt
- Brake fluid - 1qt
- Funnels, This and basic funnel
- Brake Clean - 2 cans
- Rags
- Gloves
- Oil absorbent mats
- Hand cleaner
- Silicone lube spray
- PB Blaster
- 2x Trash Bags
- 22” Rigid tool box #1
- Ratchet Wrenches
- Various pliers, vice grips, adjustables etc
- Various screw drivers
- Hammers, Ball Peen and 3lb Sledge
- Various taps
- ½” Ratchet
- ⅜ Socket set
- 22” Rigid Tool Box #3
- Angle grinder
- Drill
- Sawzall
- Battery Charger
- Various blades (Diablo all the things), drill bits etc
- In Floor Storage Compartment
- Under Rear Seat - Craftsman Box
- Soldering Iron
- Solder
- Wire Stripper
- Various wire
- Various connectors, end, plugs etc
- Electrical tape
- Wire ties
Last edited: