Vg33 crankshaft timing gear puller

3dmasters Sep 16, 2018

  1. 3dmasters

    3dmasters Test Drive

    Messages:
    6
    Location:
    California
    Hello Guys,
    I just wanted to post a way I was on youtube for a vg3.0 engine.
    I need to remove this gear to replace the front main seal.
    Parts needed,

    2 each 6MM X 1.0 X 100MM grade 8 or higher
    6MM tap and a 5.2MM drill bit http://www.lowes.com IRWIN HANSON 2-Pack Metric Tap and Drill Set
    1 steering wheel puller kit from http://autozone.com
    Center punch http://www.homedepot.com

    RUST RELEASE PENETRANT SPRAY WD40

    Part 1,


    Part 2,


    Give any Feed back guys good or bad

     

Share This Page