Uca Cam Bolts

kryter Jul 21, 2020

  1. kryter

    kryter First Fill-Up (of many) Supporting Member

    Messages:
    258
    Location:
    colorado
    heres my question.. Had an alignment done, have SPC ucas and they set caster at 3.5. Have nonadjustable lca cam bolt.. Going to pick up the cam bolts tomorrow and Install. have serious tire rub at the back wheel liner when clocked left and right, spacer fender trim has been done.(33 in MTs) Going to install cams my self Just need to know if moving rear out and the front in will give me the clearance I need.. front bumper is going away so that is not an issue..Btw have an alignment set up for Friday Thanks all B
    should be LCA not UCA
     
  2. jsexton

    jsexton Wheeling Supporting Member

    Messages:
    476
    Location:
    Lewis Center, OH
    yes. I keep my LCA's rotated all the way forward (rear pushed out, front pulled in), and adjust with the UCA's. Even just pushing the rear side out and keeping the front neutral helps. Just have to go with whatever works with your available UCA adjustment (I don't know if you are stock width or titan swapped)
     
  3. kryter

    kryter First Fill-Up (of many) Supporting Member

    Messages:
    258
    Location:
    colorado
    1 1/4 spacers .. thats what I will do when I pick up the cam bolts tomorrow then When I take it in friday will leyt them know to adjust toe caster already at 3.5 so should be good Thanks Jexton
     

Share This Page