Trailer Light Wiring Question

[jconway23]

So I recently acquired a pop up camper. I was just going over everything with it once i got it home and stuff. While messing around with it in my driveway. I noticed I don't have marker lights when connected to my X. The popup is used so I immediately thought the issue is with that. Well after grabbing my test light I realize its with my X. I tested at the 4 part wire and all I have it blinkers and brake lights. I then removed the plug from the location under the rear and tested there. Same thing. Blinkers and Brakes.

So the only thing I can think of now is its not working because I have LED's in all my lights? I do have the load resistors on all of the lights as well. My marker lights work fine as well. (front and rear)

Any suggestions.... Keep in mind this is all factory wiring. I didn't change anything.


Jesse

 

[maillet282]

Do you know if the relays in the passenger kick panels are installed? Have you towed with the x before and of so did the lights work on that trailer ?

 

[NoahSki]

You need the 7 Pin harness. If you look where your 4 pin plugs in near the rear axle there is a second plug that is covered. That is where the other half of the 7 Pin plug goes.

 

[jconway23]

Wow I didn't know if anyone replied. So much for notifications. LoL. Anyway. The hookup on the trailer is 7 on the tongue to 4 pin. My x only has the 4 pin installed. As for towing with it. Yeah i towed my boat but in the day time. I never checked anything with marker lights though.

As for the 7 pin hookup. I never noticed it next to the 4 pin one. I will have to check that out.

Sent from my SAMSUNG-SM-G870A using Tapatalk