- Location
- Denton, TX
What is a bluetooth console? Any benefit over just adding a sunglass holder for a switch panel?You don't want that. You want a Bluetooth console from a 2nd Gen. I swapped mine out. It worked fine.
What is a bluetooth console? Any benefit over just adding a sunglass holder for a switch panel?You don't want that. You want a Bluetooth console from a 2nd Gen. I swapped mine out. It worked fine.
Look at my build thread. I swapped the std overhead console for the Bluetooth module. And mounted all my switches in it.What is a bluetooth console? Any benefit over just adding a sunglass holder for a switch panel?
Yeah. That's the place.Several Altimas and Maximas in the Littleton U Pull, down on Santa Fe.
Ok, nice..Look at my build thread. I swapped the std overhead console for the Bluetooth module. And mounted all my switches in it.
Last time I needed something like that I just got it from autozone.Anyone know where I can get some fender liner clip nuts and the black pan head screws for cheap?
Is there a computer reset needed after Cam Sensors replacement?? Or did I just buy junk sensors?? (Standard Motor Products)
I've seen a lot of people have problems with non-OE cam/crank sensors. I have a Standard Motor Products oil pressure sensor that's worked fine for years though.
I'm worse off now, before it was just a hard start but once started she ran fine, now after replacing the two Cam Sensors she won't get any gas and getting both Cam Sensor codes...so FN frustrated
You'd probably be better off just running the originals until you can get better replacements.
I just hope that it's simply bad sensors and ordering the Hitachi ones from RockAuto, she'll be sitting until then I'll use the Mrs car "Turbo" as she calls it till then...the pain in my chest from having to lay across the engine to reach those to female dogs is not looking forward to doing it again...can we get some damned room to work with in modern vehicles already?!?!?
Does anybody know if the Titan shares the same coilover upper mounting bolt pattern?
so the muffler on the gen 2 fell the ufck off on the way back from camping the other day. what are the specs for a 2 in 1 out flowmaster delta 50 seris to fit a gen 2?
Does anybody know if the Titan shares the same coilover upper mounting bolt pattern?
They are different.
Are there potential issues using the same ground for too many add on?
Anyone know if frontiers and xterras share same mud flap mounting style? I’m thinking about getting some rok blokz mud flaps but only specifically stated for Frontys.
2 days old, 1st time off road in it, 2 of 4 were cracked and the other two were pulled off at least one mounting screw and were sitting unlevel. They all got pulled the next day.Mud Flaps.... (If you wheel) You know what they say..... Take 'em off, or tear 'em off, but they're coming off.
Become a post whore.How do I change "Bought an X" on my profile?
Or do something memorable and an admin will gift you a titleHow do I change "Bought an X" on my profile?
Like balance a muffin on your head?Or do something memorable and an admin will gift you a title
Gifting someone some low profile Baja designs lights sounds pretty memorableOr do something memorable and an admin will gift you a title
I’ll send my address and we can get it processed so you can remember tomorrowI don't remember that..
I'll send you some eBay Designs chinaman lights. I'm sure those will turn out to be memorable when you install them, they break a week later, and you get to uninstall them lol[/QUOTE *when the $2 eBay specials break*
Only sealed for 0% humidity conditionsOr my personal favorite, they don't stop working they just fill up with water.
Only sealed for 0% humidity conditions