TGPWS 7: New Year. See if we can wash the stink off.

Status
Not open for further replies.

reaver

Lockers Installed
Supporting Member
Location
Caldwell, ID
Finished putting the drawer system back in the X at about 11pm last night. Got all the electrics hooked back up, and everything is working as it should.

Ordering a switchtec switch box today to mount in the center stack, as I don't like the switch setup I currently have.
 

CHUG

Lockers Installed
Supporting Member
It was a curiosity buy. But not there's concrete experimental evidence vs speculative....
Drown it with Whiskey!. Or Rum.

I like plain Coke, or Pepsi.. For Mixing only. Can't drink it anymore just too dang Sweet and lots addictive habit for it.

As I be sipping my Second cup of Coffee, Looking out window 0.79" Rain fell.. Wet Gonna get me third Coffee With Anti-Rain Juice applied. It's Saturday!!.
 

TerryD

Total Tease
Supporting Member
Location
Covington, Va
Checked a couple things on the wife's car today. Think I'm going to replace the downstream O2 sensor and see if that fixes the issue.....

Then did a PMF on the X. It was due. Fluid was a little dark but I didn't see any large particles come out of the pan. Pan gasket is weeping a little. Gonna have to find one of those I guess. Always something.
 

scoyoc

First Fill-Up (of many)
Location
Fort Collins, CO
I should have measured my clearance befor putting on the new tires, so it was more of a direst comparison. But…

So the my suspension has settles a bit. I didn't gain anything when measured from ground to the fenders, but when measured from ground to the slider I gained 1/2". I gained 1.7" when measured from ground to the engine skid and 0.7 when measured from ground to the rear diff. When averaged across measurements, I got 0.9" of additional clearance with the 33's and I’m sitting 3.5" above stock right now. So that’s fun!
 

Brunnie

Bumpers Installed
Supporting Member
Location
Colorado Springs
Any recommendation's on the Quick tire deflator's ? Thanx
I've purchased the "value priced ones" and out of the 4 only 2 hold the right pressure every time. I've talked with others about this and almost all recommend the Staun Deflators . The other solution that I have is I take my 2 tire inflator system and instead of connecting the compressor to the input I open the valve and dump 2 tires at the same time. Works pretty good for me.
 

JeffPro4x

Hot Pipe
Super Moderator
Supporting Member
Location
Glenside, PA
I've purchased the "value priced ones" and out of the 4 only 2 hold the right pressure every time. I've talked with others about this and almost all recommend the Staun Deflators . The other solution that I have is I take my 2 tire inflator system and instead of connecting the compressor to the input I open the valve and dump 2 tires at the same time. Works pretty good for me.
I built a 4 tire inflator/deflator. Sooooo nice!
 
Status
Not open for further replies.
Top