Stealth4x's 2011 Night Armor Build

[Stealth4x]

Username: Stealth4x
Instagram: @blackhawk_pro4x

Make: Nissan
Year: 2011
Model: Xterra
Trim: Pro-4X
Color: Night Armor

Trans: 6 Speed Manual

MODS

Tires/Suspension:
Fabtech 6" Frontier Lift powdercoated Illusion Cherry
PRG Products 8" Lift 2.0 Radflos
PRG Products rev 2 upper control arms powdercoated Illusion Cherry
Tom Woods custom drive shaft
PRG adjustable height shackles (not installed)
ARB differential cover (not installed)
Factory front sway bar powdercoated Illusion Cherry
PRG Products stainless front brake lines
Alcan 4" lift +200lb springs
PRG Produccts 3-5" lift Radflo 2.0 emulsion rear shocks
PRG Products U-Bolt flip kit
18x10 -12mm offset Fuel Trophies
315/70r18 (36x13.00) Toyo Open Country M/Ts
1.25" 6x4.5 to 6x5.5 wheel adapters

Exterior:
Shrockworks front bumper with fog lights
Shrockworks rear bumper with tire carrier
P&P Engineering 62" dual support rock sliders
Melt Mod
Fender trim
Pinch weld mod
35% tint on windshield
2% tint on front windows
1% tint on back doors and sides
1% tint on back glass
S trim Air Dam
Roof Mounted 48" Hi-Lift

Lights:
Morimoto Mini H1 Projectors
Apollo 3.0 Shrouds painted ruby red
Turn signal painted ruby red
Housings color matched to night armor
Morimoto xB RGB halos
Morimoto RGB demon eyes
50w 5500k HID bulbs
35w 6000K HID fog lights
2 BriteNiteLED cubes in bumper
20 inch BriteNiteLED bar on bumper
40 inch roof mounted BriteNiteLED bar
BriteNiteLED strobe controller for the 40" bar
2 Flush mount BriteNiteLED pods on rear bumper
5x BriteNiteLED rock lights
4x GlowProLED 1' red LED strips
Vision X rock lights (not installed)

Interior:
Pioneer AVH-X2600BT double din head unit
JL Audio 13w6
4x JL Audio C2-650x
JL Audio Slash series 300/4 amp
JL Audio HD750 monoblock 750w amp
ATrend dual 12" ported box
Cruiser Gear 550lb paracord grab handles
2x JL Audio C2-350x (not installed)

Other:
Uniden 520XL
Firestik II 3' red CB antenna
Firestik SS-3H Heavy Duty Stainless Steel Antenna Spring
FireStik K-8 18 foot Coax Cable + 6' to get to swingout tire carrier
OTRATTW Contura V switches with red independent lower lights and green dependent upper lights for all my lighting


Performance/Engine:
Bully Dog GT Platinum Tuner
Nismo Cold Air Intake

Future Mods:
Gobi/other full replacement roof rack
Dual batteries
PA system
Some sort of custom sub box for the back
JL Audio C5-650 and ZR800-CW in front doors
JL Audio C5-650 in rear doors
JL HD600/4

PHOTOS

Current pictures:

 

[Stealth4x]

Reserved

 

[Slasa]

Looking good! That is coming from another 6spd, Night Armor owner that looks pretty darn similar so I an extremely biased.

 

[Stealth4x]

Looking good! That is coming from another 6spd, Night Armor owner that looks pretty darn similar so I an extremely biased.

Thanks, I love how yours looks too! I'm probably getting trail graps after the mtrs wear out and a gobi stealth is on my future mod list, so maybe our Xs will look even more similar at some point. As long as you don't get the same wheels as me when I get new tires, I'll be fine with having yours looking close to mine.

 

[Stealth4x]

Little update since the last time I've been on here. I got my OTRATTW switches installed, replaced the JL G6600 with a JL Slash series 300/4, added 12 one-foot led strips for rock lights, tinted my tail lights, and jumped in on the P&P Engineering GB and am getting 62" type 2 sliders with 2 supports. I'm probably going to paint the remaining plastics and roof rack darker black to complete the look, has anyone else done this and have any paint to recommend?

 

[Stealth4x]

Put on Level 8 MK6 wheels 17x8 +0 offset with 295/70r17 nitto trail grapplers, defintely an improvement over the MT/Rs. I had to cut more metal off of it and cut the pinch weld, but they can turn fine. Also replaced the GlowProLED led strips woth BriteNiteLED rock lights, which are significantly brighter. Also mounted a hi lift to the roof, replaced the Hertz door speakers with JL C2-650s in the front and back, swapped the red firestik for a black one, mounted a 48" hi-lift to the roof, added CruiserGear paracord handles and put in GlowProLED red interior lights.

 

[rolling rock]

WOW! That is one nice build!!

 

[Prime]

Switch install is awesome! Nice job. Loving all the lights.

Do you have any close up detail shots on your projector retrofit? I've never seen one in OE 2nd gen housings before. What are your opinion on the minis? I did the mini d2s in mine and I realized later that I should have gone with the huge 3" Lexus units.

 

[Stealth4x]

Switch install is awesome! Nice job. Loving all the lights.

Do you have any close up detail shots on your projector retrofit? I've never seen one in OE 2nd gen housings before. What are your opinion on the minis? I did the mini d2s in mine and I realized later that I should have gone with the huge 3" Lexus units.

Since I actually got someone else to build my headlights for me, I don't have any pictures of them close up in the process. IIRC there was a group buy possibly on another forum for the Mini H1 projectors from theretrofitsource, but I didn't participate in that, so there's some people out there with them that did the build themselves. Here's a picture from HID Projectors of another Xterra with the same shrouds.

 

[Stealth4x]

So, a little change in the build. Ordered Fabtech frontier lift kit, PRG UCAs, Radflo 2.0 coilovers built to fabtech height from PRG, Radflo rear 2.0 emulsions from PRG, rear 4" lift Alcans, shims from PRG, U-bolt flip from PRG, Sway bar end-links from PRG, and extended front brake lines from PRG. Should be all on in March, thinking of powdercoating some of the suspension a cherry red color or maybe silver, but I'll see.

 

[ThompsonXterra]

Can't wait to see the lift on there. A cherry red color would look sick

 

[Stealth4x]

I have all the parts I ordered except coilovers, probably what I get for trying to deal with PRG. Ordered January 20 and shipped Friday. Hopefully will have it all on by the end of next week.

 

[drbandkgb]

Sweet!

 

[Stealth4x]

Well did a few things. Lifted it, added a rock light, got a new clutch and flywheel, and got some new headlights. Still need to lift the back more and get a driveshaft, but I like it right now.

 

[Prime]

Those headlights are badass.

 

[emtmark]

I'm loving it!


Sent from my iPhone using Tapatalk

 

[JeffPro4x]

Are you planning on leveling out the back at all?

sent from a crawlspace...

 

[Stealth4x]

Are you planning on leveling out the back at all?

sent from a crawlspace...

Yes, I need to get a driveshaft made. New wheels and tires will be on this week and I'll see where to go from there.

 

[Stealth4x]

Couple things done since last time. Mounted up 315/70r18 (36x13.00) Toyo Open Country M/Ts, installed my Tom Woods driveshaft, installed Nismo CAI, picked up PRG shackles, and got more tint.

fresh tires

5% over 35% on front windows in broad daylight

35% tint on the windshield

nismo intake

new driveshaft

 

[jljansen]

Is her pooping?

 

[Stealth4x]

lol that's where I park at my friends house that flexes out the front on the back at the same time.

 

[Stealth4x]

Installed PRG shackles, but it still rubs on the plastic on the fender instead of the metal like before. Also got my diff cover and trailer hitch powder coated to match the suspension.

 

[jljansen]

Dude, this thing is a beast. Hope you run straight pipes.

 

[Slasa]

Looking great! I love those wheels. Don't worry though, I won't get the same (looking way back to when you first posted the build [emoji846])
Time for some custom rear corners!

 

[Stealth4x]

Dude, this thing is a beast. Hope you run straight pipes.

lol no, my intake and tuner is enough sound for me I'm scared of what this v6 would sound like with an exhaust

Looking great! I love those wheels. Don't worry though, I won't get the same (looking way back to when you first posted the build [emoji846])
Time for some custom rear corners!

I'll probably sell it before I put corners on it or even really do anything else to it

 

[Rhaas]

Broken Images.

 

[Prime]

Thanks for bringing this one up. In the future, use the "report" button at the bottom of the post so our image guys know about it.

 

[Rhaas]

Thanks for bringing this one up. In the future, use the "report" button at the bottom of the post so our image guys know about it.

Will do! Thanks for telling me