P&P Engineering 2nd Gen Rock Sliders - Mounting Points

P&P

Need Bigger Tires
Site Sponsor
Location
Middle TN
I've seen some discussion about mounting points of sliders on 2nd gen trucks. There are a few different methods from various companies and this is ours. We go a step farther than just shoving a bolt into the through holes. For the front and middle mounts we use a high strength steel pin to sleeve the frame. The pin is thicker than the DOM tubing used for the top rails and it is welded to our backing plate.

We then use a 5/8" grade 8 bolt to make the connection.

Our rear mounts utilize 2 factory threaded holes in the frame. For us this is a very solid connection process.

IMG_4078_1024x1024.JPG
 

P&P

Need Bigger Tires
Site Sponsor
Location
Middle TN
There are 2 slotted holes in the frame. The same ones most people use to mount to. Difference Being we just sleeve the hole in the frame with the thick pin.

1E9E1968-11E9-4B26-91B3-84F01B742CFD_zps7gethprh.jpg




IMG_3817_zps0004a6e2.jpg
 
Top