Me!Here!'s Grey Beast

Me!Here! Aug 1, 2019

  1. Me!Here!

    Me!Here! Bought an X

    Messages:
    116
    Location:
    Somerville, MA
    All drawers are cut, waiting on my Dado set to cut the finger joints...

    What's left is finish the drawers, build the vertical and horizontal wings, paint and mount the mat with tie downs and lastly the electronics...dual battery set up, two relay/fuse boxes, power inverter and most excitingly the OBA set up

    Trying to figure the tool layout for the tool drawer

    tools.JPG
     
    Xterrorista likes this.
  2. Me!Here!

    Me!Here! Bought an X

    Messages:
    116
    Location:
    Somerville, MA
    Table has been cut as well
     
  3. TerryD

    TerryD Sliders Supporting Member

    Messages:
    827
    Location:
    Covington, Va
    "Thrown randomly"
     
    Me!Here! likes this.
  4. Me!Here!

    Me!Here! Bought an X

    Messages:
    116
    Location:
    Somerville, MA
    I'll have two drawers for tools, one for thrown randomly and this one with Kaizen foam, I do not wwant to listen to the wrenches and sockets rattling around...east coast potholes roads! lol
     
    TerryD likes this.
  5. Me!Here!

    Me!Here! Bought an X

    Messages:
    116
    Location:
    Somerville, MA
    Getting closer to adding some lights, and the Dual Battery,

    In the drawer system I have a 15" x 17" area allocated for the boxes and Aux battery. I decided to go that route simply for ease of access...fold down the 40 Rear seat and will have full access.

    SO here's my rough wiring diagram with the products being used

    Wiring so far 5.jpg
     
    wickedCircuits likes this.
  6. Me!Here!

    Me!Here! Bought an X

    Messages:
    116
    Location:
    Somerville, MA
    Busy weekend (I hope) going to replace two new (crappy apparently) cam sensors, grabbed an endoscope to help with the job, The Beast has been out of commission for a week now, and hoping to get my drawers built so I can prep for paint> I generally only have one day on a weekend to work on the truck so this drawer project is taking FOREVER...I cold have gone with simple butt joints but I want it Solid so finger joints will be the route for the drawers
     
    Xterrorista likes this.

Share This Page