If you have a factory bumper there should be plastic brackets in it to mount fog lights. You will will just need to pop or cut the plugs out of the bumper. If you are lucky their might be wires already ran for the fog lights (not all xterras have them ran from factory). If the wires are there then you can change the stock for the lights to one made for fog lights if not then you will have to run wires and either put them on a switch or figure out how to wire them up to a stock.Hi guys I seen first gen xterra with led pods in the factory foglight location and i was wondering if theres any write up how to do this is how its done?
Where are you wanting to mount them at? If in stock fog light location take the fog lights out and put the pods in and wire it up. If somewhere else lay out where you want to put them mark your holes drill the holes bolt them on wire them up.I have the factory fog lights and wires but how will i be able to mount the led pods?
So what you're mean is to juss drill a hole in the top of the foglight housing? Will that be sturdy?