Hazard lights switch bypass for turn signals

[onechristian]

Dear Terranthusiasts:

I am in a bit of a pickle... while making some electronic mods I've removed a couple of console panels, including the one with the hazard light switch, leaving the harness exposed out of the console space.
While I wait for completion I still drive the vehicle, it seems that without the switch the turn signals do not operate.
If anyone knows of a bypass, i.e. a jumper wire solution into this harness to trick it into recognizing the switch so I can operate my turn signals? Or perhaps which wire or terminal to be grounded as a workaround?
I feel funny signaling with my left arm out the window: that is what I do now. I appreciate any and all responses!

 

[Prime]

I'm sure we could come up with something based on the wiring schematics. But. I had to do that a few times on my 1st Gen as well. I just pulled the hazard switch out of the center stack and plugged it in so the turn signals would work.

 

[onechristian]

Thanks! I am embarrassed to admit, but I've misplaced the whole center stack panel with the switch! That at the time being leads me to try and find how to "jerry-rig" it, which in this case, would be safer than driving with my arm stuck out the window... I suppose I should specify the vehicle is the 2004 1st Gen 4 cyl SE...