westslope
Wheeling
- Location
- Wildfire country, BC
Howdy,
Finally got the Wheel Bearing and Hub Assembly (WBHA) out of the spindle and am ready to re-install/replace a list of components.
With regards to the WBHA and where it snugs into the spindle, should I cover those surfaces with grease or with anti-seize? Just in case I require taking the WBHA out again.
The WBHA and spindle surfaces where the two pressed together were corroded and required a bit of work with slot screw drivers and a 4 lb. hammer via a small piece of 2X4 to get it out.
Finally got the Wheel Bearing and Hub Assembly (WBHA) out of the spindle and am ready to re-install/replace a list of components.
With regards to the WBHA and where it snugs into the spindle, should I cover those surfaces with grease or with anti-seize? Just in case I require taking the WBHA out again.
The WBHA and spindle surfaces where the two pressed together were corroded and required a bit of work with slot screw drivers and a 4 lb. hammer via a small piece of 2X4 to get it out.