gauge installation

[Joey]

Ok gentlemen I am going to install a oil pressure, water temp, volts and transmission temp. gauge. I was wondering if anyone had did its and if I have to leave the stock sensors in place for the ECU.

I've purchased the tow max gauges made by glow shift. They are the 2" dia. gauges.

 

[Muadeeb]

My suggestion is to always leave the stock sensors in place. There are two water sensors, the one closer to the front with only one wire is for the dash, the rear one with two wires is did the ecu. The oil sensor is just an idiot light switch.

Sent from the 4th circle via directionally confused otters

 

[Joey]

feaking cool thank you! So I can use the front hole for the water and the OEM block mount for the oil. Nice, There is no point in leaving my existing gauges wired up. They are not right at all, my dash is freaking out all the time.