Front end lighting

AvalancheX

Test Drive
Location
Blairsville, GA
90000CA6-5B2B-4D8E-A94D-F30E8B812217.png1416B7A0-3639-4741-8FA2-296BE9C9BCDE.png I’m looking to do a front end lighting upgrade soon and this is what I’ve come up with... 2 side shooter pods for ditch lights, a 25” bar for the center of bumper gap and some 6” floods for a fog light replacement. I’m currently running a stock bumper and considering doing the bumper cut to make these 6” floods work. Any thoughts?
 

ffxcores

[fully disclosed]
Supporting Member
Location
Virginia
I don’t think 25” will fit in the front grille without cutting the sides. Especially with outward flush mounting tabs. I had a single row 22” in mine, which was nice because it didn’t require cutting the three support plastic pieces, but it only worked because the tabs were elevated and I could reverse them inward. Any double row bar will require cutting the plastic tabs.

Definitely don’t put a flood pattern in the fog position, because you’ll blind everyone…unless you’re only planning to use them at night on a trail.
 
Top