Crawler Gears From A D O?

TerryD Jan 14, 2020

  1. TerryD

    TerryD Total Tease Supporting Member

    Messages:
    2,491
    Location:
    Covington, Va
    @AllDogs Offroad

    Saw some teasers on FB about some possible crawler gears for the 2nd Gen in the works? Can you confirm/deny?!?

    My transmission output is starting to leak again so I may be pulling my t-case in the near future anyways....
     
  2. JeffPro4x

    JeffPro4x Hot Pipe Super Moderator Supporting Member

    Messages:
    9,854
    Location:
    Glenside, PA
    Where are these teasers?
     
  3. TerryD

    TerryD Total Tease Supporting Member

    Messages:
    2,491
    Location:
    Covington, Va
  4. JeffPro4x

    JeffPro4x Hot Pipe Super Moderator Supporting Member

    Messages:
    9,854
    Location:
    Glenside, PA
    TerryD likes this.
  5. TerryD

    TerryD Total Tease Supporting Member

    Messages:
    2,491
    Location:
    Covington, Va
    Well, I'd seriously consider a set for my X if they were available. The factory low isn't anything to sneer at but a set around 4:1 would be great off-road. But planetary sets are harder to do than the gear swap in a toyota case. IIRC the TeraLow kit for the NP231J came with a whole new front case half because of the change in the planetary set.

    I was just wondering what they were planning.
     
    JeffPro4x likes this.
  6. AllDogs Offroad

    AllDogs Offroad Test Drive

    Messages:
    2
    Hey guys! Can confirm it's something we're looking into. We have some videos of the tcase cracked open on our facebook page. We're in the process of taking measurements and working with gear shops to see if this will be a cost effective project
     
    Smileyshaun and TerryD like this.

Share This Page