Brake light on after doing SAS

akuria Aug 30, 2015

  1. akuria

    akuria Wheeling

    Messages:
    561
    Location:
    San Francisco, CA
    So after completing my SAS my brake light won't turn off. I have no idea why it won't turn off either. Any suggestions?


    Sent from my iPad using Tapatalk
     
  2. granitex

    granitex Skid Plates Founding Member

    Messages:
    1,386
    Location:
    Columbus OH
    check the fluid level first
     
  3. Jbat

    Jbat First Fill-Up (of many)

    Messages:
    274
    Location:
    Utah
    Brake light on the dash like ABS light? Or brake light in the taillight?
     
  4. Deadpilot

    Deadpilot <img src="http://i164.photobucket.com/albums/u7/ra Founding Member

    Messages:
    724
    Location:
    Fallbrook, CA
    I know I'm a 2nd Gen but my brake light came on at 1st even with everything good then after short drive the computer figured everything sort of out. Still have abs light on but yeah....
     
  5. xterror04

    xterror04 Site sponsor Founding Member

    Messages:
    1,294
    Location:
    Carlisle, Iowa
    Did you swap the rear axle? Is the brake fluid low?
     
  6. akuria

    akuria Wheeling

    Messages:
    561
    Location:
    San Francisco, CA
    I didn't swap out the rear axle. I also swapped the master cylinder for one out of a Dodge Ram 98. Brakes are bled and fluid is at the right level. Just the light stays on like I have the parking break on still but I don't.


    Sent from my iPhone using Tapatalk
     
  7. Deadpilot

    Deadpilot <img src="http://i164.photobucket.com/albums/u7/ra Founding Member

    Messages:
    724
    Location:
    Fallbrook, CA
    There may be a senor off the old master that ram doesn't have or the pressure is different between the two masters and X doesn't like that
     

Share This Page