Battery Terminal Upgrade

RM975 Jun 15, 2020

  1. RM975

    RM975 Bought an X Supporting Member

    Messages:
    99
    Location:
    Templeton, Ca
    My battery was getting crowded and unsightly.

    I bought a set of these.

    20200615_123538.jpg

    A little trimming with the band saw was necessary to allow the fusible link module fit down on it.

    20200615_142704.jpg

    The bolts are 10mm x 1.5. I replaced the one that holds the fusible link module with a longer bolt.

    20200615_144534.jpg
     
  2. Zack.

    Zack. First Fill-Up (of many) Supporting Member

    Messages:
    358
    Location:
    Livermore, CA
    Looks useful. What all do you have connected on there?
     
  3. TerryD

    TerryD Total Tease Supporting Member

    Messages:
    2,385
    Location:
    Covington, Va
    Those look nice.
     
  4. RM975

    RM975 Bought an X Supporting Member

    Messages:
    99
    Location:
    Templeton, Ca
    Winch, OBA, and power to a 60 amp panel for radios and lights.
     
  5. westslope

    westslope First Fill-Up (of many) Supporting Member

    Messages:
    288
    Location:
    Wildfire country, BC
    Looks terrific!

    OBA? On Board Air system?
     
  6. RM975

    RM975 Bought an X Supporting Member

    Messages:
    99
    Location:
    Templeton, Ca
    Correct!
     
  7. XterraRising

    XterraRising Test Drive

    Messages:
    47
    Location:
    Utah
    Where is the compressor for your OBA? Do you have a tank, or run straight from the compressor?
     
  8. RM975

    RM975 Bought an X Supporting Member

    Messages:
    99
    Location:
    Templeton, Ca
    My compressor is up front to keep it out of as much dust and tire debris as possible, on the radiator bash plate right below my winch. My rear swing away bumper is the tank.
     
    XterraRising likes this.
  9. XterraRising

    XterraRising Test Drive

    Messages:
    47
    Location:
    Utah
    very cool!
     

Share This Page