Alpine Spirit

Alpine Spirit

First Fill-Up (of many)
Founding Member
Location
South Park, CO
New Coilover Mounts bit more HD

101_0615800x600.jpg


101_0616800x600.jpg
 

Alpine Spirit

First Fill-Up (of many)
Founding Member
Location
South Park, CO
Yep shock hoop from the Calmini kit, lengthened 2". Bolts right into the mounts and there is a support running underneath to help absorb som stresses.
 

xterraminator

Wheeling
Location
Maple Ridge,BC
Alpine spirit, I like the look of your truck, will be very similar to what I am doing with mine now except I will be using coil spring and shock setup. One question on one of the pictures, above your track bar you have a bar that connects to one side of the frame to the other. Its horizontal. What is this for? You don't see that too often. Also your drag link and tie rod setup its a Y config, did you just by the rod ends and just buy your own DOM bar? BTW I now know who to contact for SAS set-up.
 

xterraminator

Wheeling
Location
Maple Ridge,BC
On your knuckles were you able to maintain the 0-3 deg castor angle. Its usually 3 deg back. Its nice to see your track bar and drag are on the same plane. most people make that mistake. I have to buy a lower track bar bracket that gets welded to the axle and it centerline where the heim joint will be about 3-4" higher than axle. Should be fun when I get to that point.
 

Alpine Spirit

First Fill-Up (of many)
Founding Member
Location
South Park, CO
On your knuckles were you able to maintain the 0-3 deg castor angle. Its usually 3 deg back. Its nice to see your track bar and drag are on the same plane. most people make that mistake. I have to buy a lower track bar bracket that gets welded to the axle and it centerline where the heim joint will be about 3-4" higher than axle. Should be fun when I get to that point.

Yep knuckes were cut and turned by grandpa it returns to center very well.
 

xterraminator

Wheeling
Location
Maple Ridge,BC
Maybe I am missing something but what are these switches doing? Are they to control solenoids for the air control on the air Lockers?

Sent from Samsung Note 2 using Tapatalk
 

Alpine Spirit

First Fill-Up (of many)
Founding Member
Location
South Park, CO
Maybe I am missing something but what are these switches doing? Are they to control solenoids for the air control on the air Lockers?

Sent from Samsung Note 2 using Tapatalk

Lockers, wiring them the way I want them to work, Sometimes having the front locker able to work is nice with out needing the rear to make a tight turn or needing the rear to spin independently.

Lights, I have lights ive busted over the years so replacing those and redoing the wiring at the same time.\

Frayed wiring, I also have some wiring that was chewed on.

So if im doing that IM putting it all into one day and redoing everything. Lots o wire and wire wrap but it will be done.
 
Top