install

  1. P&P

    Nissan Xterra Rear Recovery Point Installation Instructions Gen I (2000-2004

    Nissan Xterra/Frontier Rear Recovery Point Installation Instructions Gen I (2000-2004) Time Required: 60-120 minutes Difficulty: 4.5/10 Tools Required: Jack Center punch Jack Stand hammer Wheel chocks Drill with ¼”...
  2. P&P

    Nissan Xterra/Frontier Gen II Slider Installation Instructions

    Nissan Xterra/Frontier Gen II Slider Installation Instructions These instructions can be printed from our support page here: http://engineeringpp.com/support.html Time Required: 30-60 mins Difficulty: 3.5/10 Tools Required: Torque Wrench ~150ft-lb capacity (2) Jack Stands...
  3. Levi_Xterra

    Help Installing LED light bar

    So my Ironman 4x4 light bar comes in today. I was going to take it to an off road shop to have it professionally installed but they are wanting to completely rip me off. I haven't installed one before so im looking for any tips/advice or videos that y'all have regarding installing one. It's a 20...
  4. D

    2000-2001 CB install Cobra Ultra III

    Ok so this is my CB install I did in the dash of my 2001 Xterra. This will work on the 2000-2001 Gen 1 Xterra's but no other.. First you must pull the plastic ring off from the radio.. This is very easy because there is only two screws at the bottom of the ring. As you can see the two holes...
  5. RATTFINK

    How to: Xterra Rear Speaker Install 1st Gen

    Xterra Rear Speaker Install Approx. time: 15min - 20min. Skill level: EASY Step one: Copy and print the installation sheet (image) below. I received the instructions from Crutchfield Food for thought; Use a flathead screwdriver and your hands to remove the plastic panels & DO...
Top