Search results

Just curious, what is the benefit of going through a JDM import versus just getting a used motor from a local wrecking yard? Yes. Using the general "an engine needs air, fuel and spark" to fire up thought process and assuming air isn't an issue, I first squirted a little gas into air intake...

ok, so pulled the distributer cap this weekend and it is not turning. In fact I couldn't even turn it by hand, not even a wiggle. Plus I broke off one of the cap screws in the distributer. So that didn't go very well. I guess I'm going to start searching through the engine swap threads and...

got it.... thank you very much.

I apologize if this was covered someplace else. I did a forum search and looked through all the DIY mod list and didn't see anything about this, but my question is, can you swap a set of 2nd Gen rear bumper corners with the built in steps onto a 1st Gen X? I see there are after market steel...

Check the distributor for what exactly? Do you mean replace cap and rotor, or is there something specific I should be looking into? It has 170K plus so I imagine the timing belt will need to be replaced.

Hello all. My name is Leon and this is the story of how I became an Xterra owner. My GF always talked about how she wanted an old Land Rover or Jeep or older off road style vehicle. I'm not a Jeep guy!!! So about a week ago we saw an Xterra in a parking and she says...."I've always like the...