Search results

Okey dokey i i ha the upper control arms and I have some leaf brackets that push the leafs down about 3" I'll post pics and message after bit

I don't know how much these control arms lift it the bolt on ball joint is sitting at less of an angle and down farther than an oem control arm I will post a pic after bit

I have one with aftermarket bolt on ball joints and lifted control arms that's tubular but the bushings for the frame side are shot!

Ucas? Upper control arms?

And I'm ok with that the cleaner they can be picked I can get them cut up and sent to scrap to appease the wife...lol my Xterra habit is starting to irritate her

I'll have to see what'd it cost me to ship it but can't imagine it being that much! I'd say prolly $20 tops

I have one that has 3" lift blocks and two with the idler arm braces!

Ok guys I'll get back with you later this week I'm backed up removing parts!

Ok I'll message you this week for the address and name to ship too!

Id probably say $5 or $10 for the net and no more than a few bucks for shipping!

I took the best one and built it from parts out there and that's the one in the picture of my profile! And yes I have 7 cargo nets 2 grey, 2 tan and 3 black

Awesome thank you

Yes the brace went on without any issues and the bushings are strong and new and yes it's an oem idler arm but the arm itself bends and i i cant post a pic at the moment

I had to remove my radio and temp bezel and the lower kickpanel to remove screws

I tinted the windows, put in all new tie rods, ball joints, upper and lower control arms, idler arm, pitman arm, oil change, new distributor and idle air control valve, new exhaust manifolds, new valve cover and oil pan gaskets, new rear leafs, 33/12.50/15s and a newer front bumper! Also did a...

What front bumper is that? I have the same one and have spent hell trying to find lights!

This is a screenshot of it!

If you pop off the plastic backs to the cruise and radio controls it's two phillips screws to remove them and two 10mm bolts for the airbag removal, be sure to disconnect your battery!

Hi guys I'm a new Xterra owner and have recently been buying parts xterras and now I have a boneyard of about 22 xterras and am pulling and shipping out oem used parts! From late 90s to 2006!