Search results

Ran down Phantom Canyon after checking out the changing Aspens.

Cleaned up the sorry looking butt plastics and have the front bumper/suspension and frame a fresh coat. (Bumper got 2 coats of Steel-it, frame got the engine paint). Prepped with 180 grit sanding sponge and some wax and grease remover.

SOLD

I have the same issue, changed motor mounts because one was bad and still there. Got a Bullydog tuner and raised idle by 75 rpm and that pretty much solved it for a long time. Only once did I get a CEL (P0507) when it was really hot out and idling with the AC on max. I have since dropped it...

I need to do that titan master cylinder upgrade next! Nice Progress on the swap so far!

New MK2’s all around to replace the leaky Radflo’s.

I have a brand new set available, I'll let go for $100 plus shipping.

Like new (16/32 tread depth) Toyo Open Country 285/75r17 (34” tire), Load Range C. They have roughly 2000 miles on them. Pics speak for themselves. No damage or plugs, I just cleaned them up so they are looking fresh. I have five (5th one is brand new, but I am willing to sell just the 4...

Picked up a set at Overland Expo this weekend. Quality piece of kit and wiring harness. I went with a spot/flood pair, meaning one light is a spot and the other is a flood. The control pad has the options for 5 different power settings from 5%, 25%, 50%, 75% and 100.

Quick start up video. https://drive.google.com/file/d/1WBHxWK8Ky417dI-H9g42OZ5To9hzm6Dn/view?usp=drivesdk

No sir, no help as far as that goes.

I don’t think it was too bad of wait. I was out of town when I ordered it so don’t remember.

I have that AFE hi tuck. Easy install for me, you notice it’s there, especially off road, under throttle at low speeds. But I like it as it’s up out of the way and I don’t have to worry about it getting caught up on anything.

Doesn't look too bad, as long as you have a 24" extension for the top bolts it's probably only a couple hour job.

Last couple weeks got Powerstop brakes, AFE exhaust and an Odyssey battery and some lighting installed. Also got the ARB wired up and while doing the brakes got a bad stud replaced on one of the wheel spacers. Tomorrow the motor mounts are getting replaced, truck vibrates pretty bad and with...

It kinda was I suppose. Been stuck overseas on the job since January due to all the virus stuff.

Got the M203 cleaned up and painted. Hefty Tube bumper painted and installed along with the winch. Need to cut the grill and figure out how to mount the control box. Today the M226 gets cleaned up/painted and PRG diff cover installed. Then tackle the HIDprojector headlights. Titan swap will...

Bit the bullet, soon to be fully locked with 4.10’s. I’ll be getting an ARB for the M205 and then start collecting parts for the Titan swap.

I've seen Leatherman, Gerber, Cold Steel, Ka-bar and Benchmade.

I recently picked up a Civivi Elementum after watching Best Damn EDC on Youtube. Not much time with it so far but it does appear to be a good quality pocket knife at just $50. https://www.bladehq.com/item--CIVIVI-Elementum-Liner-Lock-Knife--104241 @TheCrabby1 I bought my wife a Wusthof...