Hey guys I have a shockworks rear tire carrier bumper ill like to sell, i got awhile back and got it on for a bit but decided to no use anymore and its been sitting in my storage units, It has some slight rust with juss some sanding and paint it will be like new... I havent have time to get some...
Hi guys I seen first gen xterra with led pods in the factory foglight location and i was wondering if theres any write up how to do this is how its done?
Thats the driver exhaust manifold. Does your engine have a egr if so theres a pipe that goes under the egr. If your engine dont have a egr then you can juss plug that with a bolt.
Awhile back I saw that P&p engineering had rear recovery point for the first gen that bolts up to the frame, which they no longer make them anymore and I was wondering if anybody was able to make or mock upsomething similar to it with the factory bumper?
Lighting looks nice and bright. I bought some auxbeam with the cooling fans awhile back and had problems with the driveside keeps going out, im thinking it was due to the way how the fan clutch was spinning. It spins to the driver side so which means hot air will heat soak the driver headlight...
Thanks Ben, so that means that the 90 degree bend next to the fuel regulator, behind the supercharger I can cap it off? If so can the bend be use for a boost gauge?
Hey, Ben Im in the middle of this supercharger install but I dont have the bcs so where does the vacuum from the the bypass actuator go too if i dont have the bcs?
Hello everybody, new to the forum. I got a 2002 Xterra in silver metallic for about 4 years, been doing maintenance and got the pml on it with some american racing wheels, sitting on 265/75/16...