Search results

Not one of the more typical mods, but the stock bushings give up pretty quickly, especially with 35's. There is quite a bit of movement with the stock bushings. I ordered these from PRG. I was a little worried at first, because the sleeve was very loose in the bushings out of the box, but once...

I know this is a part you don't see changed out too often, so I figured I would post a few pics showing how i did mine. I also recommend replacing the U-joint on the transfer case end of the DS if it wasn't done recently. I developed a real bad rattling noise, which is why I changed the DS CV...

Ready to put in my 3 set of motormounts. My originals were in there for 80-90k or so, but were completely shot when I replaced them. Replaced them with some aftermarket (eagle or something?) from rock auto, I feel like they gave up after 1-2 wheeling trips. I dont think my engine is really...

As they are getting cheaper, I feel like the Xterra is becoming the next XJ. Cheap to get, will wheel pretty good stock. Cheap to get on 33's.

Yes, many of us have this wonderful bumper. The bushing in my swing arm must be shot. Is replacing with the same crappy bushing my only choice? Or has anyone come Up with something better, like fitting real bearings?

Just rolled 120k on my X, which means that's 20k miles on 35's over about 3 years. I was told it was going to be hard to handle, not be a good daily driver, be a chore to handle on the highway, etc. Nah, it's been pretty cool. I Still drive my kids to school in it, my wife still takes it to the...

I heard all the cool kids are here, so I had to stop in too I bought this truck new in 2005 for my wife to drive when my son was born, after 70k miles we bought her an Altima, and I decided to keep it for myself, since the dealer had just put a new trans in it(SMOD!). I heard you could fit...