Search results

have 3in alcans @700lbs . right now on last hole of prg shackles and have maybe 1in of rake. have all except coil overs for a titan swap thinking I need a bit more arch in the rear to clear 35s. no BL going to cut front fenders, should I go 5in arch or 4 for A bit of rake after the upgrade?

Any recommendations... It gets highly abused

Found the rim chewer on red cone

So. Now have a set of factory skids for sale. The motor and transfer skid are doubled up. Bought a second set and bonded them together. Just want to make what I spent on the additional skids. $40.00. No shipping. They are going to scrap in a week.

have the nisstec brake line kit front and rear. Waiting on the EHT pads probably next week. so Ive replaced pads and flushed the break system before with no issues but replacing the lines is going to make one giant air bubble in the system times FOUR...any guidance wood be appreciated hydro's...

heres my question.. Had an alignment done, have SPC ucas and they set caster at 3.5. Have nonadjustable lca cam bolt.. Going to pick up the cam bolts tomorrow and Install. have serious tire rub at the back wheel liner when clocked left and right, spacer fender trim has been done.(33 in MTs)...

Kryter Nissan 2014 Xterra Pro4x Blue Hefty sliders Maxterra rear bumber OME rear spring.. modified '' alldog triple al PRG shackle bilstien 5125 rear shocks SPC UCAs Radflo ext trav coilovers w 650lbs spr hefty al front bumper w 10500 winch hefty full skids eng steel all else AL M205...

UCA ,extended radflos and brake lines ordered. have new leafs, shackles and bilstien 5125s... ufck that's a lot this spring

just seeing whats out there

just picked this up tonight for the 05. Need to clean strip and recoat. cheers

Username: kryter Make: Datsun Year: 2005 Model:Xterra Trim:S Color:Shiny Black Code Name:blak PRG ultimate rear lift nisstec mk coilovers falken wildpeak 285/75/16 hefty sliders pro4x skid plates nisstec shock skids nisstec front recovery mounts curt rear hitch aka rear skid plate w custom...

So After my last trail run (Yankee hill) some thing was clicking on the way home. After further investigation the driver side inner tie rod is shot. So should I just go ahead and replace all 4 or just the 1 that is ufcked. going to ouray for a week on the 20th so I think all 4 would be...

its funny seeing the x from 2017 it had mud flaps still on it