Search results

Thanks for the great write up! I did this last weekend very helpful. Hardest part was getting the wires thru the rubber boot. Should the symbols in the mirrors light up? They do get warm 87degs.

I had seen a post on here about changing the plastic heater hose ends with brass pex tee. Searching around rockauto site I stumbled on these from Dorman, Boom!!! $10 and $35 for the long pipe RockAuto NISSAN > 2014 > XTERRA > 4.0L V6 > Heat & Air Conditioning > Heater Hose / Pipe Fit perfectly...

The Black Brick

Thanks, that make sense

So I put the gas cylinder kit that was on eBay for a Navro and it fits perfectly. Getting rid of the prop rod and lifts the hood about 4” taller. Also put a led under hood light that hopefully never need.

Hi, getting ready to change the ATF and filter in my 2014 X 2WD has only 40k on it. Looking at Valvoline Maxlife ATF its rated for Nissan J or S. Also rear diff C200 going to use (unless I hear otherwise) Mobil 1 75-140w GL-5 ? Not too worried about the diff changed it when I put on the new...

Ya, I couldn't find much info ether. Thanks for the response

Hi, it was unpaired, just wouldn't install to the ECM. I called BD and they did a update to include the 2014 X all is fine now. Wondering what settings anyone is using. Do you advance timing ect. ?

Hi, I have a used Bulldog 40415 I got off Ebay $300 shipped (the only place that would ship to Calif because our "moral Superiors" won't allow us to have nice things). Problem is it will not install the file to the ECM giving code 440 (an unknown error). Monitoring works fine but the BD update...

Thanks, Do you install posi lockers in 226?

Thank You Sir

Thanks, if I had to do it again I'd set the U-bolts a little lower raising the rack up to 1/2" up off the roof I'm about 1/4" off the roof now.

Zack below is correct, ch4x4.com

I don’t know if I got the lights for the switches or the other way, but I seen them on eBay looked cool and fit right in the blank holes next to mirror control

I made my roof rack couple weeks ago. I wanted something that sat low between the roof bars and didn’t break the bank. Cost about $120 in steel and u-bolts and a spool of .03 flux core wire. Made from 1” sq .062 wall tubing. U- bolts from McMaster are 2” insulated bored out to 2.170 to fit the...

You are correct, no indicator light. Thanks for ur time

I'll take a closer look tonight after work and report back. Thanks

Fog lights on should show up on instrument panel correct?

Hi, I added fog lights and new turn signal stock to my 2014 Xterra X and would like the instrument panel indicator lite to show when their on. Anyone have this issue?