- Location
- McMinnville, Orygun
All fluids are Clean and fresh.. No oily anal seepage, . life is good.. Other then the Dam Evap canister short circuit crap.. codes cleared again.
Me!Here!
Bought an X
- Location
- Somerville, MA
Installed Alexa in the rig, love being hands free
- Location
- Livermore, CA
Pulled this bad boy out of my tire the other day. Seems it was just in the trad as the pressure has been holding.
- Location
- Ontario Canada
Installed a new NorthStar AGM battery with 1400 CCA. And while I was doing that I ended up installing new headlight bulbs.
- Location
- All over PA
Cleaned and oiled the air filter, greased spc uppers and maxterra bumper hinge. Now taking for alignment and balance in prep for drive to outer banks tomorrow.
BEEFY
I Smile when Gasoline Can Freeze
- Location
- Prince George, BC, Canada
Pulled the battery and left it the back 40 for the winter or how ever long it sits there.
- Location
- Rochester, NY
Took the sliders off after ECXC to properly protect. Since I was dumb enough to WD40 them, I had to get them stripped and acid washed. Going to clear coat them since I love that raw look with the black truck. Decided on Penetrol/marine clearcoat combo. I’ll keep all informed on durability for harsh conditions. NY salt for starters.
That is one with Penetrol and one without
Good look at Penetrol
That’s what they’re made for!! Just paid for themselves at ECXC.
That is one with Penetrol and one without
Good look at Penetrol
That’s what they’re made for!! Just paid for themselves at ECXC.
- Location
- Glenside, PA
Got my WK sliders on today.
- Location
- Denver Adjacent
Cleaned out the garage for it.
- Location
- Covington, Va
Gotta wash it after the parts delivery this weekend...
Me!Here!
Bought an X
- Location
- Somerville, MA
FINALLY found the missing hardware for my Rocky Mountain sliders...on a side and completely unrelated note I need to clean my basement work shop...
- Location
- Denton, TX
I kinda dig how your front plate hides your fairlead.. Does it just swing up outta the way by hand?
- Location
- Covington, Va
Yep! It's a Tuffy bracket but I redrilled it to use the top mounting bolts but keep it below my control pack. If you use the stock holes on the lower bolts, the plate hangs below the bottom edge of the bumper face.
- Location
- Covington, Va
- Location
- Livermore, CA
Bought this.. it’s bigger than I thought, any recommendations on a good spot to mount it (2nd gen)?
- Location
- All over PA
Drove it on the beach for a week. Now to take home and change all fluids. Sand and salt water have a love / hate relationship with me.
- Location
- McMinnville, Orygun
Added New wipers.. Broke one Plastic bracket on the driver side.. Crap.. so old Wiper Re-installed. (dam Wiper Changed brackets again..)
Passenger side new Wiper.. eh driver needs the challenge to drive.. Least Passenger will have clear view ;-) Clarity while driving is overrated!!!
Driver side 22"
Passenger side 21"
Replace Twice a year.
Passenger side new Wiper.. eh driver needs the challenge to drive.. Least Passenger will have clear view ;-) Clarity while driving is overrated!!!
Driver side 22"
Passenger side 21"
Replace Twice a year.
KC!
Bought an X
Camping fridge en route???installed my power inverter 900w
possibly, its immediate purpose is for a camping trip/trail ride that the wife and I are doing with other xterras. we're using purple lizard maps to ride trails from pa to Virginia. It'll be used for air mattress pump, laptop, small compressor... you know, trail essentials 
- Location
- Covington, Va
Where in Va are you headed?possibly, its immediate purpose is for a camping trip/trail ride that the wife and I are doing with other xterras. we're using purple lizard maps to ride trails from pa to Virginia. It'll be used for air mattress pump, laptop, small compressor... you know, trail essentials
- Location
- Glenside, PA
Well. That sounds funpossibly, its immediate purpose is for a camping trip/trail ride that the wife and I are doing with other xterras. we're using purple lizard maps to ride trails from pa to Virginia. It'll be used for air mattress pump, laptop, small compressor... you know, trail essentials
- Location
- Livermore, CA
Unplugged my dash cams last Sunday night to help prevent coming home to a dead battery tomorrow
- Location
- Covington, Va
Ok. If you wind up in the Bath, Allegheny, or Craig county areas give me a shout!
Me!Here!
Bought an X
- Location
- Somerville, MA
Benched her for the next two days, getting hard start w/SES, VDC & Slip...replacing both O2 and Crankshaft sensor...what a diff going from my girl to the Mrs' Accord
- Location
- Rochester, NY
Got my sliders back on today after clear topcoat protection. Went with the Spraymax 2K clear in satin. 2 cans ordered off fleabay did just enough for 2 coats. The diamond plates turned black from the acid wash. I didn’t color them. Now I need to rub out the paint job and de-scratch it. And yes, put the nose piece back on... I know....
- Location
- Denton, TX
Sounds like an expensive afternoon!
- Location
- Denton, TX
Looks good, I really dig the contrast of your sliders..
Me!Here!
Bought an X
- Location
- Somerville, MA
Got the 2nd set of Cam sensors in, the Mexican ones were crap, lesson learned... but good to be back behind the wheel of the X...now back to the fun stuff
General_Tarfun
Sliders
- Location
- Atlanta, GA
Those came out great, they have a nice contrast against the black.
General_Tarfun
Sliders
- Location
- Atlanta, GA
Originally thought I might install these in the dash tweeter openings but these are a little larger than I was expecting:
Nice looking rig.