Almost Stalls when coming to complete stop...

Matt Benson

Test Drive
Hello,

First, I apologize if this has already been talked about. Through searching the internet and forums I haven't found a definitive answer.

My 2011 Xterra S has always "stuttered" a little bit when coming to a complete stop. For the past two weeks after the engine is at normal operating temperature and driving a highway speeds for 10 plus minutes and coming to a complete stop the motor acts like it's going to stall, then jumps back to normal idle at 650 RPMs.

I'm going to check all my vacuum lines for leaks/cracks and clean my MAF sensor. After that I'm lost. The motor is not throwing any codes.

Thanks,
 

Prime

Shut up Baby, I know it!
Admin
Location
Denver Adjacent
There was a low idle condition on some trucks. My wife's Pathy does it every once in a while. Idle should be closer to 750-800 rpm. It takes a Consult scanner to adjust the idle. So a dealer has to do it.
 
Top