Recent content by SRStaff

  1. S

    Replacement for 4x4parts Ball Joints?

    I always use 95 pathfinder ball joints on my AC UCA'S
  2. S

    Wheel Bearing/Assembly? and Manual Hub Bolts?

    They are OEM Pathfinder studs. 97 with the full time 4WD hubs.
  3. S

    Another Bump stop question.. but different

    Make sure you get an alignment first. Once you lower your front to get the proper gap for your bumpstops; your alignment will be out of wack and the chalk test is pointless. But what Prime said on the chalk test is on point since all tires are a little different on pressure when it comes to the...
  4. S

    Another Bump stop question.. but different

    35psi should be a good pressure to run. Just watch how the tires wear. I run over 1/2" on my OEM bumpstops do to the poorly maintained roads here.
  5. S

    Another Bump stop question.. but different

    Get the OEM bumpstops from the dealer. The 40psi you are running in your tires is not helping either. Need to drop the pressure some. I bet that dash sounds great chattering every time you hit a pothole.
  6. S

    Another Bump stop question.. but different

    Oh, yeah, that will ride horrid! You need that 1/2" bumpstop gap from the OEM bumpstop height. All you are doing is slamming on the poly low profile bumpstop. The OEM rubber bumpstop will compress to the same height as the poly low profile bumpstop and be much more tolerable hitting.
  7. S

    Wheel Bearing/Assembly? and Manual Hub Bolts?

    Nissan has OEM studs and nuts to fit the Warn manual hubs. That is what I run on my Warn manual hubs.
  8. S

    Prime'z X²

    That sucks with the bondo on the fender.
  9. S

    33s no BL

    Finally got around to getting the rear spaced better. 33's tuck in nicely now and do not rub frame or body on the inboard side. Never a need for a BL.
  10. S

    Ultimate Tire Fitment Guide (Gen 1)

    Tire size: 33/10.50/15 Tire: Dick Cepek Extreme Country Wheel: OE 15" Pathfinder Lego Wheel BS: 5" Spacers: .75" Bora on rear Cutting required: major plastic cutting on front Other mods required: none Lift on truck: 3" SL both sway bars removed .75" spacers required to clear frame and body in...
  11. S

    Something to ponder

    With headers I would look around 5hp with it. TB bore and intake plenum matched is about $200
  12. S

    Prime'z X²

    Expensive boobs job. Looks pretty clean from the pics. Nice!
  13. S

    Something to ponder

    Some will appreciate this . Upper intake is matched to TB also.
Top